Independent, unofficial site · Educational only, not financial advice · Some tutorials contain invite links · Eligibility, fees and availability are set by Gate
GT Token · Fees

How to turn on GT fee deduction, and what it saves

Illustration: a finger flipping a switch on a control panel, a glass jar slowly collecting coins beside it
Flip one toggle, keep enough GT in the balance, and frequent trading gets its fees marked down. · Illustration (AI-generated), not a Gate screenshot

Short answer: on the website, Gate's VIP help page points to Fee in the bottom navigation bar; in the app, the fee settings sit under your account profile (help pages checked 2026-09-24). Switch on GT fee deduction there and keep some GT in the account. What it saves depends on your VIP level: at VIP0, spot maker and taker drop from 0.1% to 0.09%; at VIP9, taker drops from 0.075% to 0.068%; from VIP10 up, the GT rate and the VIP rate are the same number, so it saves nothing (Gate's fee page, checked October 2026; the live page wins). The rest covers the steps, how it sits with Gate Points, the arithmetic and the common mistakes.

01What GT deduction is

The logic is simple: trading on Gate incurs a fee, and once you switch on "GT deduction," that fee can be paid at a discount using the GT in your account, so up to VIP9 your trading cost gets a markdown (from VIP10 it doesn't; see section 04). The system applies the GT discount automatically when you fill, no per-trade action needed.

Don't confuse it with "holding GT to climb VIP." They are separate concepts: VIP corresponds to a fee tier, while GT deduction is an account fee-payment setting. How they combine, the actual rate and payment priority are determined by the fee and settings pages in your account. Other GT uses are mapped in the GT complete guide; this page stays on the deduction setting.

02Where and how to switch it on

The interface shifts a little between versions, but the path is much the same. Roughly these steps:

  1. Open the fee settings: after logging in, find them in the account centre or under "fees." Some versions put the entry under "assets" or the personal centre.
  2. Find the "deduct fees with GT" toggle: usually a clearly-labelled switch about using GT to pay trading fees.
  3. Turn it on: flip the switch to the on state.
  4. Make sure you hold GT: the toggle is only a setting; for it to take effect you need enough GT in the account. No GT, and an on switch still deducts nothing.

After that, just trade normally and the system discounts automatically. The exact entry location per version goes by the screen you're on; if you can't find it, searching the help centre for "GT deduction" usually locates it. Once it's on, here's how to check it is actually being applied.

The switch is the setting, the balance is the point

Plenty of people flip the toggle and think they're done, then their account has no GT and fees come out at full price anyway. For deduction to take effect, there has to be GT in the account. Keep a little GT in the balance and top it up at your trading pace, rather than finding out you're back on full price after it's been spent dry.

03Priority: GT vs Gate Points

This gets overlooked. Besides GT, Gate sometimes has other deduction credits such as Gate Points. When you've switched on several deduction methods, the system doesn't pick at random. Gate's fee page gives two rules: GT deduction and Gate Points deduction can't be switched on at the same time; and when the balance runs short, the system switches to the standard VIP rate rather than to the other method (checked October 2026).

Why care? If the ledger shows Gate Points paying while you believe GT is in use, your picture of how fast GT runs down is wrong. Since only one of the two can be on, check which toggle is actually active before you reconcile the ledger.

04How much it saves

From VIP10 up, it makes no difference

Gate's fee page lists the VIP fee rate and the GT fee rate side by side for every level (maker/taker): VIP0 is 0.1%/0.1% against 0.09%/0.09%; VIP5 is 0.09%/0.095% against 0.081%/0.085%; VIP9 is 0.07%/0.075% against 0.05%/0.068%. From VIP10 the two columns are identical; VIP10 is 0.04%/0.058% in both. Figures checked October 2026; the live page wins.

Amount saved ≈ your spot volume × (VIP rate − GT rate). An example: at VIP0, $100,000 of spot volume in a month at 0.1% versus 0.09% saves about $10; the same volume at VIP10 saves nothing. To estimate your own monthly saving, drop your volume into the GT fee-discount calculator; to work out the pre-deduction spot fee base first, pair it with the spot fee calculator. The full two-column table is in the VIP fee table.

Calculate before deciding whether to enable it

The effect depends on traded volume, account rate, available deduction methods and GT balance; a single example cannot become a universal result. It gives the method, not this site's own billing results. Estimate with your own rate and volume, then confirm the toggle, priority and actual charge in your Gate account.

05A few easily-missed gotchas

  • A low balance switches you back to the VIP rate: per Gate's fee page, when the GT balance runs short the system switches to the VIP rate. Don't assume switching it on means a permanent discount — once GT is spent dry, the discount is gone.
  • It covers spot only: the glossary on Gate's fee page describes GT deduction as paying spot trading fees, and futures fees don't go through it; futures taker fees have their own Gate Points option (checked October 2026). Any further cap goes by the fee page at the time.
  • GT itself swings: what you deduct with is GT, and its price moves. Stacking a big pile of GT just to deduct fees means counting GT's own price risk in — the fees you save may not cover one GT drop.
  • Don't assume the priority: as above, several deduction methods run in an order; follow the page, not your impression.

06Who it's for

One line to sort it out:

  • Frequent or large-volume traders: worth switching on up to VIP9, where the saving grows with volume. At VIP10 and above the GT rate equals the VIP rate, so it saves nothing and there's no reason to keep GT for it.
  • Occasional traders: no harm in switching it on, but don't stockpile a lot of GT for deduction — the saving may not keep up with GT's swings, a poor trade.
  • Pure launch players who barely trade: deduction means little for you; GT's value sits more on the HODLer Airdrop side, which splits airdrops by the GT you hold.
In short

Switching on GT deduction is a low-cost move: open settings, flip the toggle, keep enough GT in the balance. What it saves depends on your volume and VIP level: something up to VIP9, nothing from VIP10. All rates go by what Gate's fee page shows live. This is a how-to, not financial advice.

·FAQ

What if I switch on GT deduction but hold no GT?

With too little GT, the system switches to the VIP rate, so you pay your level's VIP fee without the GT price. The toggle is just a setting; taking effect also needs enough GT in the balance. The rule comes from the glossary on Gate's fee page, checked October 2026.

How much does GT deduction save?

It depends on your VIP level. On Gate's fee page, VIP0 spot goes from 0.1% to 0.09% and VIP9 taker from 0.075% to 0.068%; from VIP10 up the GT rate equals the VIP rate (checked October 2026; the live page wins). To estimate a monthly saving, run a calculator on your own volume.

Can I turn deduction off again after switching it on?

Yes. It's a toggle you can switch off or back on in fee settings any time; with it off, fees come out at the normal rate. Whether to switch it on is simply a call based on your trading frequency.

Sources

The VIP and GT fee rates for each level, the switch to the VIP rate when the balance runs short, and the rule that GT deduction and Gate Points deduction can't be on at the same time come from Gate's fee page (rate table, glossary and FAQ), checked October 2026; the live page wins. The website and app entry points come from Gate's help centre pages on VIP levels and spot fees, checked 2026-09-24.